Bring More Products Down the Pipeline with Weldclass’s Pipe Cutter Attachment
If you thought CNC plasma tables could only cut flat sheets – think again!
Cut pipes with precision with our pipe cutting solution here at Weldclass. This pipe cutting attachment fits to Samson or PlasmaCAM machines and includes DesignEdge software upgrade for pipe cutting.
If you own (or are looking to purchase) a PlasmaCAM or Samson cutting table, this pipe cutter attachment is a cost-effective add-on for low-volume and one-off pipe cutting projects.
To be clear, we should point out that this unit is NOT a dedicated or mass-production CNC pipe cutter. Keep in mind that it is an add-on accessory, not a full-time pipe cutting solution. You also need to allow 30 minutes to set up the pipe cutter on your table and 30 minutes to dismantle it.
If you’re looking for a dedicated CNC pipe cutter, check out our Bend-Tech Dragon machines – the ultimate pipe and tube CNC plasma cutting solution!
- Fits onto Samson or PlasmaCAM machine for CNC cutting on round pipe and tubing
- Shapes can be cut either within the pipe or on the ends
- The outside diameter must be between 38mm and 340mm, and long lengths can be cut through indexing.
- Includes the physical pipe cutting attachment and adds the pipe cutting capabililty level to the DesignEdge software
- Approximately 30 minutes of setup time is required to change the machine’s configuration from cutting sheet to cutting pipe and vice-versa.
How much does it cost to add a pipe cutting attachment to your CNC package? Click below to find out.
View Pipe Cutting Attachment In Action
Looking for a Dedicated Pipe Cutter?
Our range of Bend-Tech Dragon CNC Pipe Cutters are the ultimate solution!